Keywords: differential thermal analysis

Influence of carbon black additives and finely ground waste from stone wool production on characteristics of cement systems

https://doi.org/10.58224/2618-7183-2025-8-4-8
Abstract
The object of research is cement composites with additives of carbon black and finely ground waste stone wool production. The work aims to design a mix of a cement composite with the additives of carbon black and finely ground waste from stone wool production, which achieves the best strength characteristics. The results show that carbon black is represented on average by particles of 155 microns with inclusions of large agglomerates up to 1-2 mm in size, consisting of almost homogeneous nanoparticles 10-20 nm in size. Carbon black is distinguished by high hydrophobic properties with a true powder density of 900 kg/m3 and a bulk density of 300 kg/m3. The chemical composition of black carbon is 70-80% carbon and 10-15% oxygen, and it also contains impurity compounds of zinc, iron, sulfur, silicon, and other elements. Carbon additives acquire hydrophilic properties in the presence of a plasticizer, and the degree of their influence on hydration becomes less pronounced. The contraction of the binder during the first three hours of hardening is reduced when carbon black is introduced into the cement system in an amount of 8%. A composition with the best strength characteristics was obtained: the content of finely ground waste from stone wool production is 6% by weight of the binder; carbon black content is 4-5%; W/C = 0.2. However, there is difficulty in mixing the mixture at such a low W/C. With a water-cement ratio of 0.3, this problem is solved, and the strength characteristics remain quite high.
PDF

INFLUENCE OF SiO2 CRYSTAL STRUCTURE ON THE THERMAL CYCLE OF POLYMER COMPOSITES

https://doi.org/10.34031/2618-7183-2018-1-4-21-29
Abstract
Polymer composites are widely used in the space industry for the manufacture of spacecraft, satellite panels, antennas, thermostatically controlled coatings, etc. In space, they are subjected to harsh environmental con-ditions, such as ultraviolet, deep vacuum, atomic oxygen, charged particles, anthropogenic debris, micrometeoids, electromagnetic radiation and thermal cycles that cause severe degradation of the material. One of the most important environmental effects of materials based on polymers is the thermal cycle, in which the composite undergoes a large temperature difference from -170˚C to + 200˚C. The paper presents an assessment of the use of composites based on a polyalkane-rich matrix and a filler in the form of an SiO2 amorphous and crystalline structure under thermal cycling conditions. The data on the change in tensile strength, modulus of elasticity in tension and relative elongation in tension of materials after several cycles of a sharp differential temperature (from -190 to +200°C) are presented. The thermal cycle was repeated 5, 10 and 20 times. It is shown that the sample polyalkanimide has a large value of tensile strength and elastic modulus compared with highly filled composites.However, during thermal cycling there is a significant decrease in these parameters.For a highly filled composite sample with 65% crystalline SiO2 content, the decrease in tensile strength and elastic modulus after thermal cycling is insignificant and is within the measurement error. A composite with amorphous SiO2 is more susceptible to a change in mechanical properties after thermal cycling in comparison with a composite containing crystalline SiO2.
PDF