Matiushin E.V.

Candidate of Engineering Sciences (Ph.D.), Senior Lecturer at the Department of Building Materials Science, National Research Moscow State University of Civil Engineering

Role of aggregate characteristics in controlling the mechanical properties of ultra-high performance fiber-reinforced concrete

https://doi.org/10.58224/2618-7183-2026-9-5-4
Аннотация
Ultra-high-performance fiber-reinforced concrete (UHPFRC) is one of the most promising construction materials due to its superior mechanical properties and durability. Aggregates play an important role in the formation of the structure and properties of UHPFRC. In this study, 27 UHPFRC mixtures containing quartz and quartzite aggregates with maximum particle sizes ranging from 0.4 to 1.25 mm and volumetric aggregate content varied from 0 to 0.4 m3/m3 were investigated. The main mechanical properties of UHPFRC were determined, including compressive strength, flexural strength, and fracture energy. To describe the influence of aggregate characteristics on UHPFRC properties, two parameters were introduced: the total surface area of aggregate particles in the concrete mixture, Sagg,tot, and the relative number of contacts between aggregate particles and the steel fiber surface, Cg. Linear increase in the compressive strength of UHPFRC was observed with increasing Sagg,tot over the range of 0 –12.400 m², while mixtures containing quartzite aggregate exhibited 10-20 MPa higher compressive strength compared with quartz aggregate. Flexural strength and fracture energy also showed a linear dependence on Cg within the range of 0 ≤ Cg ≤ 1. At Cg ≥ 1, no further improvement in mechanical properties was observed. The introduction of aggregate increased the flexural properties of UHPFRC by up to 1.41 times. Simple empirical relationships were proposed to predict the mechanical properties of UHPFRC considering the type and content of aggregate. The correlation coefficients between the predicted and experimental values ranged from 0.92 to 0.95, demonstrating the high accuracy of the proposed models.
PDF