Vol. 9 Issue 6

Archives Journal Construction Materials and Products Vol. 9 Issue 6

Corrosion protection of St3 structural steel in aggressive water–petroleum media using cyclophosphate–metal–surfactant systems: thermodynamic and surface analysis

https://doi.org/10.58224/2618-7183-2026-9-6-2
Abstract
This study aimed to evaluate the effectiveness of the inhibitory action of multicomponent systems based on cyclic phosphates and anionic surfactants for protecting steel from corrosion in aggressive water–petroleum environments, as well as to establish the thermodynamic regularities governing these processes. The research combined experimental and analytical methods, including potentiometric and photocolorimetric measurements, IR spectroscopy, scanning electron microscopy (SEM), and the calculation of key thermodynamic parameters such as Gibbs free energy, equilibrium constants, and corrosion rates. Among the tested formulations, the most effective was the composition containing sodium cyclohexaphosphate (Na₆P₆O₁₈), nickel ions (Ni²⁺), and sodium dodecyl sulfate, which provided a protection efficiency of 46.98% and reduced the corrosion rate to 0.076 g/m²•h. The obtained results indicate that the protective effect of these inhibitors is associated with the formation of stable polyphosphate complexes in solution and the development of strong adsorption layers on the metal surface, which hinder corrosive attack. Overall, the findings demonstrate that such multicomponent inhibitor systems are promising candidates for improving corrosion protection of petrochemical industry equipment, extending service life, and enhancing the operational reliability of industrial installations. From a materials perspective, the results identify the Na₆P₆O₁₈–Ni²⁺–surfactant system as a favorable formulation for forming low-solubility passivating layers on St3 steel. Combined electrochemical, spectroscopic, microscopic, and thermodynamic evidence links reduced metal loss to protective-film formation and provides a basis for selecting inhibitor compositions for components operating in water–petroleum media.
PDF

Extra-performance concrete mix design using basalt, sawdust ash, and micro silica

https://doi.org/10.58224/2618-7183-2026-9-6-3
Abstract
This study presents an Extra-Performance Concrete (EPC) produced with recycled fine powders-basalt dust, sawdust ash, and micro silica-without using coarse aggregates. Eight mix designs were evaluated to assess the influence of these materials on compressive and flexural strengths and microstructure. The mixture, combining 43.2 kg/m³ of micro silica and 14.4 kg/m³ of sawdust ash, achieved a compressive strength of 64.35 MPa and a flexural strength of 7.63 MPa after 28 days. Scanning electron microscopy showed the formation of a dense and cohesive matrix with refined porosity and well-developed C–S–H phases, attributed to the combined effect of micro silica and sawdust ash in enhancing the interfacial bonding and reducing micro-cracking. Principal component analysis and correlation studies further supported the role of mix composition in mechanical performance. These results show the EPC as a sustainable, high-strength concrete solution for structural applications, aligning with sustainability principles.
PDF